The other thing to note is that there are many signals in our system that need to be pulled up or pulled down. Of course, there are many reasons why the signal needs to be pulled up and down, but not all. The pull-down resistor pulls a simple input signal, and the current is tens of microamps or less, but pulling a driven signal will bring the current to milliamperes. Some people think that with the addition of the pull-down, the working state of these signals will be more stable, but this will increase the power consumption of the whole machine. So when designing, you need to figure out which signals must be pulled up. If you can not pull them up, try not to use them.
Based on the above, it is necessary for our designers to have the ability to achieve higher circuit performance with limited power specifications, as well as to meet basic system performance requirements and cost targets. We need to carefully analyze the power of all components in the system to make reasonable choices of the devices and chips involved in the hardware circuit design to provide the best design.
Whether you are installing a new 12V TV in you RV or replacing an old one, you might not be sure what brand is the best. You might be familiar with the brand of 12V RV TV that comes factory installed in a motorhome, travel trailer, 5th wheel, camper or toy hauler, but is that the only option out there?